INTEL RAID GUIDE
GUIDE FOR RAID0 FOR INTEL CPU DEVICES
Last updated
GUIDE FOR RAID0 FOR INTEL CPU DEVICES
Last updated
Make sure you have windows installed on your USB as per Step 1 in normal reinstallation.
1- Turn on PC, spam the [Del] key continuously to enter the BIOS menu.
2- Select [SETTINGS] → [Advanced] → [SATA mode] as [RAID/Optane Mode]
3- Press [F10] → Select [Yes] to save and exit, your PC will restart on its own.
4- repeat step 1 again, and boot into BIOS menu.,
5- Select [SETTINGS] → [Advanced]→ select [Intel(R) Rapid Storage Technology]
6- Select [Create RAID Volume]
7- Select [RAID Level]: RAID0 or Volume if available.
8- Select all available disks. then Click [create Volume]
1- Turn on PC, spam the [Del] key continuously to enter the BIOS menu. [EZ Mode]，check the connect drive in Storage Information.
2- Press F7 key and enter [Advanced Mode].
3- Click [PCH Storage Configuration] item on the advanced page.
4- Click [SATA Mode Selection] item and set to [Intel RST Premium With Intel Optane System Acceleration(RAID)].
5- click [M.2_1 PCIE Storage RAID Support] and set to [RST Controlled]
6- Click [M.2_2 PCIE Storage RAID Support] (YES THIS IS A DIFFERENT STEP) and set to[RST Controlled]
7- Enter [Boot] page and set [Launch CSM] to [Disabled]
8- Press F10 key and click OK then the system will restart on its own.
9- Press [del] key after the system reboot and enter BIOS [EZ Mode]
10- Press F7 key and enter [Advanced Mode] as below picture.
11- Click [Advanced] page and click [Intel(R) Rapid Storage Technology] .
12- Click [Create RAID Volume].
13- Set a random RAID name and choose RAID Level: RAID0 or Volume if available.
14- Select all available disks.
15- Click [Create Volume] to create RAID.
1- Turn on PC, spam the [Del] key continuously to enter the BIOS menu.
2- Go to Peripherals\SATA And RST Configuration → make sure SATA Controller(s) is enabled.
3- set SATA Mode Selection → Intel RST Premium With Intel Optane System Acceleration.
4- In BIOS Setup, go to BIOS tab → set CSM Support → Disabled.
5- Save the changes and exit BIOS Setup.
6- After the system restarts, enter BIOS Setup again. Then enter the Peripherals\Intel(R) Rapid Storage Technology sub-menu, then press [Enter] on Create RAID Volume.
7- Enter a random volume name with 1-16 letters (letters cannot be special characters/ please do not use stuff like dick/n1gger/funny names) under the name and press [Enter].
8- select RAID0 or Volume if available. Next, use the down arrow key to move to Select Disks.
9- Under Select Disks item, select all hard drives to be included in the RAID array. Press the [Space] key on the hard drives to be selected (selected hard drives are marked with "X").
10- Move to Create Volume and press [Enter] to begin.
11- Check if RAID volumes are created.
→
→